Panasonic PN25168-NZ Installation Manual page 4

 Do not install this Ethernet Switch at the location with continuous vibration or
strong shock, or at the unstable location.
Deviation could lead to falling, injury and/or equipment failure.
 Do not put this Ethernet Switch into fire.
Deviation could lead to explosion and/or fire.
 Double pole / Neutral fusing
 Use the bundled power cord (AC 100 – 240 V specifications).
Deviation could lead to electric shock, malfunction, and/or equipment failure.
 Unplug the power cord in case of equipment failure.
Deviation, such as keep connecting for a long time, could lead to fire.
 Be sure to connect the ground cable.
Otherwise this might cause electrical shocks, misoperations and malfunctions.
Connect the Ethernet Switch via the supplied power cord to the outlet which is
connected to the ground.
If the outlet is not connected to a ground, connect the ground cable (AWG18:
green/yellow) to the ground terminal screw.
 Connect the power cord firmly to the power port.
Deviation could lead to electric fire, shock, and/or malfunction.
 If the STATUS (Status) LED blinks orange, unplug the power cord since this is a
malfunction.
Deviation, such as keep connecting for a long time, could lead to fire.
 Handle the Ethernet Switch carefully so that fingers or hands may not be
damaged by twisted pair port or power cord hook block.
 When connecting IEEE802.3at-enabled receiving equipment to the Ethernet
Switch, use a CAT5e or above cable. Using cables other than those could lead
them to cause heat to be generated, to catch on fire and/or cause
malfunctions.
 This Ethernet Switch is to be periodically serviced in order to maintain its
performance.
Please assign a product administrator, and be sure to implement periodic mainte-
nance. When doing maintenance, check the inspection chart that is posted on our
website which has the requisite items listed on it.
 When using this Ethernet Switch to design systems, use it after applying
appropriate measures such as setting up redundant configurations.
Communication failures might be generated due to causes such as malfunctions or
misoperations while the Ethernet Switch is being used.
4
WARNING
CAUTION