Preparing The Water Block For Installation - EK-Quantum Vector2 Trio RTX 4080 D-RGB User Manual
Gpu water block
Hide thumbs
Also See for Vector2 Trio RTX 4080 D-RGB:
- User manual (23 pages) ,
- Manual (21 pages) ,
- Quick start manual (16 pages)
Table of Contents
Advertisement
PREPARING THE WATER BLOCK FOR INSTALLATION
DO NOT REMOVE
STANDOFFS
FROM SCREWS!
BACKPLATE STANDOFF
BACKPLATE
PCB
CARDBOARD
M2.5 x 8 AX1
STEP 1
STEP 1
Unscrew eight (8) Screws AX1 M2.5 x 8 mm. Remove the backplate
together with the Screws and backplate standoffs. Standoffs must stay
on Screws AX1 M2.5 x 8 mm. Remove the PCB cardboard. Save the
removed parts for later steps.
Do not remove standoffs from screws! In case the
standoff detaches from the screw, replace it with a
spare one. When replacing the standoff make sure
that you screw it on the AX1 M2.5 x 8 screws. Do not
push the standoff onto the screw AX1 M2.5 x 8 mm.
For this step, you will need:
Phillips Head Screwdriver
- 8 -
Advertisement
Table of Contents
Need help?
Do you have a question about the Vector2 Trio RTX 4080 D-RGB and is the answer not in the manual?