Table of Contents
Advertisement
PREPARING THE WATER BLOCK FOR INSTALLATION
DO NOT
REMOVE
THE UPPER
TERMINAL
BADGE!
UPPER
TERMINAL
BADGE
TERMINAL
BADGE
TERMINAL
O-RING 14 x 1 mm
M3 x 10 AX1
SCREW
M4 x 20 DIN7984
SCREW
STEP 1
ACTIVE
BACKPLATE
STEP 2
STEP 1
First, remove the terminal badge which is attached to the terminal
with two magnets. Under the badge, unscrew three (3) screws
M4x20 DIN7984. Additional eight (8) screws M3x10 AX1 need to be
removed (as shown in the image).
DO NOT REMOVE THE UPPER TERMINAL BADGE!
For this step, you will need:
Phillips Head Screwdriver
STEP 2
Carefully remove the complete active backplate with the terminal.
Additional two (2) O-rings 14 x 1 EPDM50 need to be removed.
- 10 -
Allen Key 2.5mm
Advertisement
Table of Contents
Need help?
Do you have a question about the Vector2 XC3 RTX 3080 ABP Set D-RGB and is the answer not in the manual?