Preparing The Water Block For Installation; Cleaning The Pcb - EK-Quantum Vector2 FTW3 RTX 3090 Ti ABP D-RGB User Manual
Gpu water block
Hide thumbs
Also See for Vector2 FTW3 RTX 3090 Ti ABP D-RGB:
- Manual (19 pages) ,
- User manual (17 pages)
Table of Contents
Advertisement
PREPARING THE WATER BLOCK FOR INSTALLATION
DO NOT
REMOVE
THE UPPER
TERMINAL
BADGE!
UPPER
TERMINAL
BADGE
TERMINAL
BADGE
STEP 2
M3 x 10 AX1 SCREW
M4 x 20 DIN7984
SCREW
STEP 1
STEP 2
CLEANING THE PCB
Wipe off the remains of the original thermal compound using a
nonabrasive cloth or Q-tip, as shown in the sample image, until the
components and circuit board are completely clean. EK recommends
the use of denatured alcohol for removing TIM leftovers. After that,
remove all remaining stock thermal pads from the PCB.
STEP 1
First, remove the terminal badge which is attached to the terminal with
two magnets. Under the badge, unscrew three (3) screws M4 x 20
DIN7984. Additional ten (10) screws M3 x 10 AX1 need to be removed
(as shown in the image).
DO NOT REMOVE THE UPPER TERMINAL BADGE!
For this step, you will need:
Phillips Head Screwdriver
- 8 -
Allen Key 2.5mm
Advertisement
Table of Contents
Need help?
Do you have a question about the Vector2 FTW3 RTX 3090 Ti ABP D-RGB and is the answer not in the manual?