PED4000 / PED5000 Series with M61
Alarmed Exit Devices
Installation Instructions
5
Installation Instructions (for retrofi t kit, continued)
C
D
Slide the mount rail until it stops on the dogging
slope, then install the alarm insert sub-assembly
with the cylinder close to the push. Make sure
to press the switch fi rmly against the trigger
mechanism.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2023, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in
part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
a
Dogging slope
Mount Rail
Alarm Insert
Sub-assembly
a. Insert the trigger mechanism arms to the gap
on both sides of the dogging cam (if present).
b. Slide the trigger mechanism forward into the
slot at the back of the dogging slope until it
clicks into place.
c. Press and release the push rail to verify that
the trigger is properly installed.
c
b
6 E
Reinstall the rail:
a. Slide the rail assembly to the chassis.
b. Reinstall the end bracket.
c. Tighten the chassis mounting screws.
d. Reinstall the chassis cover and end cap.
7
Push Rail
Trigger Mechanism
a
d
b
c
FM618 01/23