J Setting Memory Switches - Omron SYSMAC CV500-BSC11 Operation Manual

With BASIC Units, serial port settings and other settings are performed using memory switches. This appendix
explains how to make memory switch settings.
The following two methods can be used to set memory switches. Explanations for both methods are given below.
1. From the Terminal
2. Using Support Software (e.g., CVS, SSS)
1. Setting Memory Switches from the Terminal
After the BASIC Unit is connected to the terminal, go into monitor mode as shown below.
Ok
MON↵
*
Next, make the memory switch settings as shown below.
*ESW1=1101↵
*ESW7=0125↵
When the settings have been completed, write the settings to the Unit and exit monitor mode.
*ESW-W↵
MEMORY SWITCH COPY COMPLETE
*Q↵
Appendix J
Setting Memory Switches
Goes into monitor mode
Sets ESW1 to 1101
Sets ESW7 to 0125
Writes the memory switch settings
Exits monitor mode
213