Table of Contents
Advertisement
Start-up, calibration and operation of the burner
5
From Normal mode, using the keys of the operator panel, it is possible to activate one of the three visualisation/programming modes:
Visualisation modes
Programming modes
Info mode
Visualises the general system information.
The list of the parameters that can be visualised is given in
the table below.
To access this level, press the key "i/reset" for 1 - 3 s.
Release the key immediately when the display shows "Info".
P
/reset
1..3s
List of the parameters that can be visualised (in the sequence
in which they are visualised)
167
Volumetric delivery of fuel in the unit of measurement
selected
162
Operation time with flame
163
Operation time
164
No. of resettable ignitions
166
Total no. of ignitions
113
Identification code of the burner
107
Software version
102
Control box test date
103
Identification code of the control box
104
Identification number of the group of parameters set
105
Version of the group of parameters
143
Reserved
End
Operating procedure in Info and Service modes
After access to these levels, the display visualises the number of the parameter
(flashing) on the left, and the corresponding value on the right.
If the value is not visualised, press the key "i/reset" for 1 - 3 s.
To return to the Parameters List, press the key "i/reset" for more than 3 s, or press
simultaneously the keys "+" and "-" (esc).
To move on to the next parameter, press the key "+" or "i/reset" for less than 1 s. At
the end of the list, the display visualises "End".
To move back to the previous parameter, press the key "-".
To return to the Normal/Standard visualisation mode, press the "i/reset" key for
more than 3 s, or press simultaneously keys "+" and "-" (esc). For a moment the
display will show "OPErAte".
1
Info mode (InFo)
2
Service mode (Ser)
3
Service mode (Ser)
m³
m³/h
l
l/h
%
Service mode
Visualises the log of errors and some technical information
regarding the system.
The list of the parameters that can be visualised is given in
the table below.
To access this level, press the "i/reset" key for more than 3 s.
Release the key immediately when the display shows "SEr".
P
/reset
> 3s
List of the parameters that can be visualised (in the sequence
in which they are visualised)
954
Flame intensity (%)
121
Manual setting of output
Not defined = automatic operation
922
Position of the servomotors (expressed in degrees,
symbol
)
0 = fuel
1 = air
161
Number of errors
701
Log of the errors: 701-725.01, Code
.
.
.
725
P
m³
m³/h
l
l/h
%
m³
m³/h
l
l/h
%
GB
25
Advertisement
Table of Contents
