Table of Contents
Advertisement
Installation
4
Once the combustion head adjustment is completed:
reassemble the burner on the guides 3) at about 100 mm
from the pipe coupling 4) - burner in the position shown in
Fig. 12;
insert the probe and electrode cables, then slide the burner
as far as the pipe coupling - burner in the position shown in
Fig. 17;
connect the plug of the servomotor 14) (Fig. 12) and tighten
the grommet 15) (Fig. 12);
refit the screws 2) and the split pin on the guides 3);
fix the burner to the pipe coupling with the screw 1).
2
Fig. 17
16
GB
3
1
When fitting the burner on the two guides, it is
advisable to gently draw out the high voltage
cable and flame detection probe cable until they
are slightly taut.
CAUTION
4
5
D8047
Advertisement
Table of Contents
