Yamaha XMAX Owner's Manual page 57

Periodic maintenance and adjustment
5. Insert the dipstick into the oil filler
hole, and then tighten the oil filler
cap.
To change the engine oil (with or
without oil filter element replace-
ment)
1. Start the engine, warm it up for
several minutes, and then turn it
off.
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap
and the engine oil drain bolt to
drain the oil from the crankcase.
ZAUM1119
1. Engine oil drain bolt
4. Check the drain bolt washer for
damage and replace it if neces-
sary.
1
ZAUM0129
1. Engine oil drain bolt
2. Washer
1
2
TIP
Skip steps 5–9 if the oil filter element is
not being replaced.
5. Remove the oil filter element cover
by removing the bolts.
ZAUM1120
1. Oil filter element cover
6. Remove the oil filter element and
O-ring.
1
2
ZAUM0712
1. Oil filter element
2. O-ring
3. Oil filter element cover
7. Check the O-ring for damage and
replace it if necessary.
8. Install the new oil filter element
and an O-ring.
9. Install the oil filter element cover
by installing the bolts, then tight-
ening them to the specified
torque.
6-11
1
3
6