Table of Contents
Advertisement
Section 5: Slideout Systems
Norco Slideout Manual Operation
1.
Locate the included flexible shaft in your own-
er's packet.
2.
Attach flexible shaft to the 1/4" hex fitting
on the end of the motor.
3.
Attach 1/4" socket & ratchet, or drill to the
other end, and turn in the proper direction to
move the room.
4.
5.
If the cables tighten, and the motor is diffi-
cult to turn, REVERSE THE DIRECTION.
OVER-TORQUEING CAN HAPPEN,
RESULTING IN SEVERE DAMAGE.
Power Gear Slideout System
Manual Override - The slideout system is equipped with a manual override that allows you
to extend or retract the room in the event of a loss of power.
Always disconnect battery from system prior to manually operating
system. Failure to disconnect battery can cause electricity to back feed
through the motor and cause serious damage to the system as well as void
the warranty
Use EXTREME CAUTION when extending/retracting the room us-
ing the manual override feature. The gears can be stripped out if the
room is manually retracted/extended to its fullest extent and the operator
continues to rotate manual override. Damage can also occur to the slide
components, slide room structure or trim components. Damages due to
misuse of the manual override feature will void any and all claims to the
Limited Warranty.
If the room does not move when the switch is pressed, check the following:
Make sure the slideout system is turned on.
Battery is fully charged and connected.
Transit bars have been removed (if so equipped).
68
Maintenance Record
Table of Contents
Advertisement
Table of Contents
