Garnet 709-RVC NLP Manual page 9

4. When the programming mode is entered, the display will
show "FrS" if entering the number of senders for the fresh
tank, "GrS" if entering the grey tank, or "bLS" if entering the
black tank. When this occurs release both buttons.
5. The display will now show "0SE" (zero senders/disabled),
"1SE" (one sender) or "2SE" (two senders), based on what is
currently programmed into the display. These are the only
three options; the display will not work with more than two
senders per tank.
6. To change the number of senders, press the tank button, each
time the button is pressed the display will increment one
number.
7. When the display shows the correct number of senders, press
the BATT button to exit the programming mode. Each tank
will need to be calibrated individually using this procedure.
To program the alarm set points for each tank (FRESH/GREY/
BLACK):
1. To program the alarm point for each tank, the display needs
to enter the alarm programming mode.
2. To enter the alarm programming mode, press and hold down
the button for the tank to be programmed, the display may
show a level or an error message for that tank.
3. While continuing to hold down the button for the tank, press
and hold down the BATT button. The display will immediately
show "dIA" (diagnostics), continue to hold down both buttons
until the display enters the alarm test menu, this should take
about 5 seconds.
4. When the alarm test menu is entered, the display will show
"ALr" for about 5 seconds. Release the buttons.
5. Depending on which tank is selected and the status of the
alarm, the display will show a simulated low fluid level below
the alarm set point (FLo, GLo, bLo) or a high level above the
alarm point (FHi, GHi, bHi). The alarm test menu allows the
alarms to be manually activated to test. The same tank button
toggles the simulated fluid level between low and high.
6. To set the alarm point, press and hold the same tank button,
after about 3 more seconds, the display will show "FAS",
"GAS", or "bAS", depending on which tank is selected. Release
the button.
709-RVC NLP Manual
Page 9