(without limitation) compensatory, direct, indirect or consequential damages, loss of data, income or profit, loss of or damage to property and claims of third parties. For the avoidance of doubt, VIBE does not limit its liability for death or personal injury to...
Mounting Guidelines Your VIBE enclosure is designed with a swift installation routine in mind. Please mount the enclosure in a dry location on a solid surface. NEVER mount the enclosure upside down as this will cause the amplifier to over heat and will eventually damage the amplifier.
Power Cable • At least 10 gauge cable should be used for the power connection to the amplifier. • The power cable should be taken directly from the battery. Rubber grommets should be used when passing through any bulkheads to prevent the cable from becoming chaffed or cut.
Page 6
Terminals And Connections 1. Power / protect LED If the amplifier is operating normally, the GREEN LED will illuminate. If the amplifier is in protection mode the RED LED will illuminate. 2. Phase switch This switch is used to set the phase of the amplifier and is adjustable between 0° (off) or 180° (on). 3.
By using the crossovers correctly you will not only lengthen the life of your speakers but you will also get better performance from them. To optimise your setup seek the advise of a professional installation engineer or visit your local VIBE audio dealer.
Page 8
Designed and engineered in England Designed and engineered in England www.vibeaudio.co.uk www.vibeaudio.co.uk www.vibeaudio.co.uk www.vibeaudio.co.uk www.youtube.com/vibeaudio www.youtube.com/vibeaudio www.youtube.com/vibeaudio www.youtube.com/vibeaudio www.facebook.com/vibeaudio www.facebook.com/vibeaudio www.facebook.com/vibeaudio www.facebook.com/vibeaudio www.twitter.com/vibecaraudio www.twitter.com/vibecaraudio www.twitter.com/vibeaudio www.twitter.com/vibeaudio...
Need help?
Do you have a question about the SLICK C10A and is the answer not in the manual?
Questions and answers