Table of Contents
Advertisement
.............................................................................................................................................................................................................................................
5‐6. Function of Auto On‐Off (Power saving mode)
BT‐Q1200Ultra supports Auto On‐Off (Power saving mode). It can automatically
enter sleeping mode after the Bluetooth connectivity is turned off, so the Blue LED
will turn to flash every 5 seconds. Thus you can always power it on with very low
power consumption.
Under power saving mode, when detecting Bluetooth is being connected,
BT‐Q1200Ultra will auto wake up itself and the blue LED will turn to flash every 2
seconds and GPS Orange LED will be also On.
Note: Power saving mode would not function when log is enabled.
6. Setup BT‐Q1200Ultra
6‐1. Install the driver and software utility for BT‐Q1200Ultra
System Requirement (Only compatible with Microsoft Windows XP / Vista)
Minimum System Requirement
‐ Windows XP or Vista
‐ Pentium 3, 500Mhz
‐ 128M RAM
‐ 128MB disk space
‐ Network speed: 128Kbits/sec
‐ 3D‐capable video card with
16Mbytes of VRAM
‐ 800x600, "16‐bit High Color" screen
Beyond
Navigation
BT‐Q1200 Ultra Super 51‐CH GPS Travel Recorder
Recommended System Requirement
‐ Windows XP
‐ Pentium 4 2.4GHz+ or AMD 2400xp+
‐ 512M RAM
‐ 2 GB of free disk space
‐ Network speed: 768 Kbits/sec or
better (DSL/Cable)
‐ 3D‐capable video card with 32 MB of
VRAM or greater
‐ 1280x1024, "32‐bit True Color" screen
®
8
Advertisement
Table of Contents
