Table of Contents
Advertisement
.............................................................................................................................................................................................................................................
5‐4. Charging Battery
For the first time using the BT‐Q1200Ultra,
please charge battery until it is fully charged.
Take the power cable and connect it to the
power jack (mini USB type) and recharge
through USB cable, travel charger, or car
cigarette adaptor. This will begin to charge
the battery. Charging time is about 3 hours
typically.
‐ When the Power LED is Red, battery power is low status. Please recharge.
‐ When the Power LED is Green, the battery is under charging mode.
‐ When the Power LED is blinking, the battery is fully charged.
NOTE: The Cigarette Adaptor can only be used to charge BT‐Q1200Ultra. Please
don't make use of it with devices other than BT‐Q1200Ultra.
5‐5. LED Indicators
LED Status
Power
(Red/Green)
Bluetooth
(Blue)
GPS
(Orange)
Log (Blue)
Beyond
Navigation
Flash
Low Power (Red)
Fully charged (Green)
Flash per 2 sec.:
Bluetooth connected and
transmitting Mode
Flash per 5 sec.: Power
saving mode
Flash per 1 sec.(Orange):
GPS position is fixed,
Navigation
Log Mode is on
BT‐Q1200 Ultra Super 51‐CH GPS Travel Recorder
Recharging
(Green)
Not
connected
/Pairing
Detecting
Satellite, GPS
position not
fix
Memory is
full
ON
OFF
GPS not
powered /
Log Mode
is on
GPS not
powered
Log Mode
is off
®
7
Advertisement
Table of Contents
