About this task
To install the front cover, complete the following steps:
Procedure
1. Position the cover (A) on the front of the system unit so that the four pins on the system match the
four holes on the rear of the cover.
Figure 103. Installing the front cover
2. Press the tabs (B) to snap the cover into position.
3. Close the front rack door.
Placing the 31E/2B, 31E/1C, or 31E/2C system into the service or
operating position
Use these procedures to place a system into the service position or operating position to perform service
or to gain access to internal components.
Placing the rack-mounted 31E/2B, 31E/1C, or 31E/2C into the service
position
Use this procedure to place the rack-mounted system into the service position.
Before you begin
Notes:
v When placing the system into the service position, it is essential that all stability plates are firmly in
position to prevent the rack from toppling. Ensure that only one system unit is in the service position
at a time.
126
Disk drives or solid-state drives for the 02E/4B, 02E/4C, 05F/6B, or 05E/6C