1) Turn on the audio source (TV or audio component)
2) Switch the ON/OFF
switch on the headphone
3) Place the headphones-
on your head and adjust
control to the desired
band lets you adjust the length of the headphones
4) Tune the frequency
control, located on the back of
to a mid-level
setting. Just rotate the thumb-
wheel knob up or down and leave it set approximately
of the range.
5) Adjust the tuning
dial of the headphone
to the frequency
for best reception.
You should now be able to walk freely from mom to room without disruption. If
disruption should occur (signal breaks up), adjust the headphones tuning control
to maximize stereo reception.
If you hear interference horn other components, readjust the tuning control.
the control on the transmitter to a different setting then adjust the control
on the headphones to match the new setting.
may have to try a few loca-
tions to find one with no interference.
When transmitting/receiving over long distances, the signal from the system will
become weaker and the stereo indicator light will go dim.
For protection of the transmitter and to save power, the transmitter will cut off
automatically in about one minute when the input signal from the audio source
is too weak for operation. If the signal is restored, the transmitter will work