STEREO INFRARED HEADPHONE WITH FLAT TRANSMITTER Thank you for choosing RCA Wireless Headphones. You have selected a fine product designed to provide years of performance. Before attempting to use your Wireless Headphones, please remove all parts from the box and read the installation and use instructions carefully.
INTRODUCTION This infrared (IR) wireless headphone system transmits stereo sound signals throughout the room allowing you to enjoy music or sound privately from any audio or video device. With a range of up to 25 feet, you may have freedom from wires while listening to your TV, video or audio CD in the same room.
EXPLANATION OF CONTROLS ON THE IR STEREO TRANSMITTER (see figure 1 below) IR transmitting LEDs,to transmit the audio signal to the IR headphone Power on/off switch DC input connector, to power the IR transmitter Recharge cable, to charge the batteries of IR headphone Input stereo audio signal cable with 3.5 mm jack connector (FRONT) (BACK)
INSTALLATION 1. Connect the audio signal cable located on the back of the transmitter to the headphone jack of your audio source. This headphone jack is located on the front panel of most TVs and stereo receivers. Insert the plug on the audio signal cable into the headphone jack.
EARPAD AND BATTERY COVER AAA SIZE BATTERY Figure 4 OPERATION 1. Switch on the (IR) transmitter and position it in a location at approximately the same height as that of the headphone when it will be in use. This system operates using IR light signals that are invisible to the human eye.
RECHARGING 1. Switch off the power of the headphone before charging. 2. Note: Before using the IR headphone for the first time, please ensure that the batteries are fully charged (for 16 hours). This will guarantee a longer operating life for the batteries. 3.
IR TRANSMITTER OPTIMUM 35° 35° LISTENING RANGE HEADPHONES 25 FT. RANGE OF TRANSMITTER Figure 5...