To Exit Remote Start Mode Without Driving The Vehicle; To Exit Remote Start Mode And Drive The Vehicle - Dodge Charger SRT Hellcat 392 2016 Owner's Manual

• The park lamps will turn on and remain on during
Remote Start mode.
• For security, power window and power sunroof op-
eration (if equipped) are disabled when the vehicle is
in the Remote Start mode.
• The engine can be started two consecutive times with
the key fob. However, the ignition must be activated
by pushing the keyless ignition button twice (or the
ignition must be placed in the ON/RUN position)
before you can repeat the start sequence for a third
cycle.
To Exit Remote Start Mode Without Driving The
Vehicle
Push and release the Remote Start
allow the engine to run for the entire 15-minute cycle.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 29
NOTE: To avoid unintentional shut downs, the system
will disable the one time push of the Remote Start
button for two seconds after receiving a valid
Remote Start request.

To Exit Remote Start Mode And Drive The Vehicle

Before the end of 15-minute cycle, push and release the
UNLOCK button on the key fob to unlock the doors, or
unlock the vehicle using Passive Entry via the door
handles, and disarm the Vehicle Security Alarm (if
equipped). Then, prior to the end of the 15-minute cycle,
push and release the keyless ignition button.
NOTE: For vehicles equipped with the Keyless Enter-
N-Go — Ignition feature, the message "Remote start
active - Push start button" will display in the Driver
button one time or
Information Display (DID) until you push the START
button.
2