Dodge Charger SRT Hellcat 392 2016 Owner's Manual page 436

434 STARTING AND OPERATING
Preconditions:
• Launch control should not be used on public roads.
Always check track conditions and the surrounding
area.
• Launch Control is not available for the first 500 miles
(804 km) of the vehicle's life.
• Launch Control should only be used when the engine
and transmission are at operating temperature.
• Launch Control is intended to be used on dry, paved
road surfaces only. Use on slippery or loose surfaces
may cause damage to vehicle components and is not
recommended.
Launch Control is available when the following proce-
dure is followed:
1. Push the LAUNCH button on the center stack switch
bank.
NOTE: Pushing the SRT button on the center stack or
pressing the "Apps" button on the touchscreen are two
other options to access launch control features. Please
refer to "Uconnect Settings" in "Understanding Your
Instrument Panel" for further information.
2. Push the "Launch RPM Set-Up" button on the touch-
screen. This screen will allow you to adjust your
launch RPM's for optimum launch/traction.
3. Push the "Activate Launch Mode" button on the
touchscreen.
4. Make sure the vehicle is not moving.
5. Make sure the steering wheel is pointing straight.
6. Hold the brake and make sure the vehicle is in "Drive"
or "AutoStick" position.