Idrifttagning Och Underhåll; Demontering Och Sluthantering - schmersal RSS 36-D-ST5 Manual

Table 3: Tabular overview of status signals, warnings or error messages(The described condition is reached, when Bit =
1)
Communication
directions:
Bit n°
Bit 0:
Bit 1:
Bit 2:
Bit 3:
Bit 4:
Bit 5:
Bit 6:
Bit 7:
8 Idrifttagning och underhåll
The safety function of the safety components must be tested. In the case of correct installation and adequate use,
the safety switchgear features maintenance-free functionality. A regular visual inspection and functional test,
including the following steps, is recommended:
1. Check fixation of the safety switch and the actuator.
2. Fitting and integrity of the cable connections.
3. The system is free of dirt and soiling (in particular metal chips).
I säkerhetsbrytarens alla driftsmässiga livsfaser ska konstruktivt och organisatoriskt lämpliga åtgärder vidtas avseende
2
manipulationsskydd resp. mot hantering av säkerhetsanordningen, exempelvis genom användning av en
reservtransponder.
Skadade eller defekta enheter ska bytas ut.
2

9 Demontering och sluthantering

Request byte:
Response byte:
Warning/error byte:
Request byte
---
---
---
---
---
---
---
Error reset
from the PLC to the local safety sensor
from the local safety sensor to the PLC
from the local safety sensor to the PLC
Response byte
Safety output activated
Actuator detected
---
---
Input condition X1 and
X2
Actuated in limit area
Error warning
Error
(enabling path switched
off)
21-22
Diagnostic
Error warning
Error output Y1
Error output Y2
Cross-wire Y1/Y2
Temperature too high
---
Internal device error
Communication error
between the field bus
Gateway and the safety
switchgear
---
Error messages
Error output Y1
Error output Y2
Cross-wire Y1/Y2
Temperature too high
Incorrect or defective
actuator
Internal device error
---
---