Control Computer Setup - Omtech USB3020A User Manual

3.9 Control Computer
See your software manual for details on the requirements for the control computer. The control computer should
be connected using the provided USB cable via the port marked "PC". If you choose to use your own USB cable,
do not use one longer than 15 feet (4.5 m) to avoid possible interference on the line.
Install LaserDRW onto this computer from the flash disk and/or CD-ROM provided in your accessories pack. For
details on this installation, consult the software's separate manual. If you only received a CD-ROM but cannot use
it with your control computer, contact customer service to receive a usable copy.
Familiarize yourself with the software's image design features and laser control settings before using it to operate
your device. The software should be correctly configured but if it does not automatically work with your engraver,
go to its main toolbar and select Engrave.
Select Device Initialize and the following menu should open:
16