Safety Information; Disclaimer; General Safety - Omtech USB3020A User Manual

2. Safety Information

2.1 Disclaimer

Your engraver may differ somewhat from those shown in this manual due to options, updates, etc. Please contact
us if your engraving machine came with an outdated manual or if you have any other questions.
2.2 General Safety Instructions
• Your device should come with safety precaution labels such as those seen below:
If any labels are missing, illegible, or become damaged, they must be replaced.
• Use this laser engraving device only in accordance with all applicable local and national laws and regulations.
• Use this device only in accordance with this instruction manual. Ensure that this manual is included with this device
if it is ever given or sold to a third party.
• DO NOT operate continuously for longer than 2 hours. Stop for at least 30 minutes between uses.
• DO NOT leave this device unattended during operation. Observe the device throughout
operation. If anything seems to be operating strangely, immediately cut off ALL power to the
machine and contact either our customer service or your dedicated repair service. Similarly,
ensure the device is FULLY turned off (including by means of the emergency stop switch) after
each use.
• DO NOT allow minors, untrained personnel, or personnel suffering from a physical or mental impairment that
would affect their ability to follow this manual and the software manual to install, operate, maintain, or repair this
device.
• Any untrained personnel who might be near the device while it is in operation MUST be informed that it is
dangerous and fully instructed on how to avoid injury during its use.
• Always keep a fire extinguisher, water hose, or other flame retardant system nearby in case of
accidents. Ensure that the local fire department's phone number is clearly displayed nearby. In the
case of a fire, cut electrical power before dousing the flame. Familiarize yourself with the correct
range for your extinguisher before use. Take care not to use the extinguisher too close to the flame,
as its high pressure can produce blowback.
8