Table of Contents
Advertisement
b. The coach must be running and parking brake engaged to extend the main slide by first
pushing the RET (Retract) button for 3 to 5 seconds and then pushing and holding the
EXT (Extend) until the slide stops moving out. You can tell when it's gone as far as it will
go by the sound of the motor.
i. Note you will have to have the coach running with the parking brake engages.
The slide will not have enough power to extend with battery power only.
c. Ensure no one is sitting in the dinette seats or occupying the bunks while the slide is
moving.
4. AGS (Auto Generator Start) Setup. If you are "Dry Camping" or "boondocking" (not hooking up
to water, power or sewer) you may complete the final steps a.- c. below. If you are setting up in
an RV resort with full hookups, skip to step 13.
result in dead batteries, a warm fridge and severe delays in the morning waiting for the solar
panel and engine alternator to charge the house batteries enough to start the generator in
order to bring the slides in. Follow these steps very carefully!!!
a. On the home screen of the touch screen panel and on the electrical screen indicated by
a lightning bolt. There is AGS Enable button. Press the enable button.
b. This will ensure the generator turns on automatically when the battery voltage gets too
low.
c. If you are dry camping this completes your setup.
5. Utility connections
a. Power Hookup
i. Locate the electrical hookup in the RV space. The coach is designed for 50 amp
service but can operate everything with at least 30 amp service.
ii. Do not attempt to run the rooftop A/C units or the microwave on anything less
than 30 amp service. If the plug looks like a normal household outlet, it's not
adequate for the A/C or microwave.
iii. Ensure the breaker on the power panel provided by the RV resort is in the OFF
position.
iv. Retrieve the cable and appropriate adapter from the outside compartment on
the driver's side. If the end of the long cable matches the outlet provided by the
RV resort, then you will not need an adapter. If it doesn't, find the adapter that
fits the outlet provided and hook the two together.
v. Plug the end with the spanner nut into the connection on the left rear side of
the coach. It has a square cover. Lift the cover rotate the plug until the bumps
line up with the slots and it goes in easily. Push in as far as you can and then
rotate the spanner nut onto the threads to ensure it won't be accidentally
removed.
vi. Plug the other end of the cable and adapter (if using one) into the RV resort
outlet and turn the breaker on.
vii. If the breaker trips, consult the RV resort attendant for help.
b. Water Hookup
i. From the rear driver's side door compartment, open the clear container with
that has the water hose in it and retrieve the hose.
CAUTION: Going to bed without AGS enabled will
9
Advertisement
Table of Contents
