Camp Setup Procedures/Checklist; Auto Generator Start Setup - Thor Motor Coach Omni BB35 2020 User Manual

g. Awning
i. Ensure it has been completely retracted and stowed in place.
h. Slides
i. Ensure it is completely pulled in on both sides.
i. Hookups
i. Check to make sure all water, power and sewer hookups have been
2. From the inside
a. Ensure all counter tops and tables are properly cleared with items that may fall or move
while under way.
b. Ensure all seat belts are easily accessible.
c. Ensure all cabinet doors are closed securely.
d. Ensure all windows are closed securely.
e. Ensure all rooftop vents are closed securely.
f. Ensure shower door is properly secured.
g. Ensure cabover bed is stowed properly (no blankets or bulky items on mattress)
3. From the driver's seat
a. Turn the ignition key on and watch for the yellow coil shaped light to go OFF
b. Start the engine.
c. Disengage parking brake.
Camp Setup Procedures
1. Find a level, even parking spot.
a. When backing, use a spotter, open the driver's side window and be sure you can
communicate clearly.
b. If backing in the dark, have your spotter use a flashlight.
2. Levelling the coach
a. With the engine running, engage the parking brake.
b. DO NOT ATTEMPT TO MOVE THE VEHICLE PAST THIS POINT!
c. Verify that the leveling jacks will have a flat surface when they hit the ground.
d. Press the power "ON/OFF" button on the self-leveling system located to the right of the
entrance when entering the coach. You must press and hold for a few seconds for the
power to come on
e. Then press the auto level button. The coach will then proceed to level the unit.
f. Ensure there is little to no movement inside the coach while this process is taking place.
g. It is not necessary to evacuate the coach while this process is taking place.
h. If no error light on the levelling control panel presents itself and the coach seems level,
proceed to the next step.
i. Press the "ON/OFF" button on the self-leveling system.
3. Extend the slide
a. On the touch screen home screen there is a slide EXT (Extend) and RET (Retract) option.
disconnected and stowed properly.
8