Table of Contents
Advertisement
a. Water Hookup
i. It would be a good idea to refill your on-board fresh water tank prior to
departure so you have some supply for your next travel leg.
ii. Disconnect the hose on both ends and return all items back to the same clearn
container it came from.
iii. Replace the water supply access cover.
b. Drain the waste tanks prior to departure.
i. Grab another pair of rubber gloves to protect you from any bacteria.
ii. Ensure the sewer hose connections are secure and open the black water drain
valve first by pulling the handle straight out.
iii. When it seems most of the tank is empty, close the black valve by pushing it
back in and open the grey valve the same way. Doing the grey water last will
rinse out the hose ensuring no waste is left in the hose.
iv. When the grey tank seems empty, close the grey valve.
c. Sewer Hookup
i. Ensure both the black and grey drain valves are pushed all the way in and
closed.
ii. If you've used the slinky sewer hose supports, fold them up and return them to
the appropriate container in the double door storage compartment.
iii. Remove black/orange sewer drain hose from the black connection of the coach.
iv. Pull it out of the access hole and replace the sewer hose access cover.
v. Lift the end of the sewer hose up into the air to ensure all contents have drained
into the RV resorts sewer.
vi. If you suspect any waste may still be in the sewer hose, turn the RV resort water
supply on and run some water down the drain hose shaking it a little to rinse it
all out.
vii. Drain the sewer hose COMPLETELY and return it to the same container it came
from.
d. Power Hookup
i. Locate the breaker on the RV resort power hookup and turn it off.
ii. Remove the cable/adapter from the RV resort's outlet.
iii. Remove the other end of the cable from the coach by turning the spanner nut
to the left. When free, pull the plug straight out.
iv. Coil the cable and place door storage compartment.
2. AGS (Auto Generator Start) Setup.
batteries, a warm fridge and severe delays waiting for the engine alternator and solar panels to
charge the house batteries to charge enough to start the generator. Follow these steps very
carefully!!!
a. Plugging the coach into shore power or manually starting the generator will disable the
AGS. So, let's enable it.
b. On the touch screen panel on the electrical screen indicated by a lightning bolt. There is
AGS Enable button. Press the enable button.
c. This will ensure the generator turns on automatically when the battery voltage gets too
low.
CAUTION: Departing without AGS enabled will result in dead
11
Advertisement
Table of Contents
