Removing The Mower - Toro Wheel Horse 78305 Operator's Manual

Assembly

Removing the Mower

1. Park the machine on a level surface, disengage
the power take off (PTO), set the parking brake,
and turn the ignition key to "OFF" to stop the
engine. Remove the key.
2. Remove the two wing nuts and belt cover from
the tractor (Fig. 11).
2
Figure 11
4. Belt cover
3. Turn knob on idler assembly clockwise to loosen
belt. Remove belt from upper mower pulley
(Fig. 12).
2
Figure 12
1. Knob
8
2
1
m–2534
5. Wing nut
1
m–2823
2. Upper mower pulley
4. Remove hairpin cotters from trunnion and
bottom of yoke (Fig. 13).
5. Unlatch and remove locking clevis pin that
secures yoke assembly to clutch shaft. Pivot
yoke out and forward to remove from clutch
shaft and engagement plate (Fig. 13).
6. Remove belt from pulley (Fig. 13).
7. Assemble yoke and engagement plate and attach
locking clevis pin, trunnion and hairpin cotters
to secure (Fig. 13).
1
2
5
4
Figure 13
1. Hairpin cotter
2. Trunnion
3. Engagement plate
4. Locking clevis pin
8. Open front hitch and remove pulley assembly
(Fig. 14).
Figure 14
1. Pulley assembly
2. Front hitch
3
7
6
1
m–3443
5. Yoke
6. Clutch shaft
7. Inside groove
2
3
1
m–2810
3. Latch