First Time Power-On - Dimplex Q-Rad QRAD050RF Instruction Manual

First Time Power-On

A setup wizard will display when the product is powered
on for the fi rst time. This will set the following:
• Time, Date, Daylight Savings Time
• Sound On/Off
For information on using the Heaters controls, refer to page
9. The Heater will then take the User to the Home Screen
with the 'Out All Day' Timer Mode active.
Operation Manual
WARNING: FAILURE TO FOLLOW THESE OPERATING INSTRUCTIONS MAY RESULT
IN INJURY AND/OR DAMAGE.
The controls are located on top of the heater. This consists of a display screen and six touch sensitive buttons.
Display Screen
1
'Menu' Button
2
'Back' Button
3
'Up and Down' Arrows
4
'Enter' Button
5
'Advance' Button
6
Heating Status
7
The heater is fi tted with an adjustable thermostat enabling the room temperature to be controlled. The minimum
room temperature is 7°C. The maximum temperature is set to 30°C. A temperature of 21°C is a common comfortable
room temperature.
NOTE:
Your heater may produce some noise during
operation. This noise is caused by the expansion
and contraction of the element as it changes
temperature, and is normal for this type of
product. Whilst the noise produced is usually
very quiet, certain environmental factors can
make it more noticeable, such as hard fl ooring
or minimal furnishings If you believe that the
expansion noise is excessive, please contact us.
7
Important
During initial heat-up, some odour
may be emitted due to the newness of
materials used in manufacture. This is
normal and will disappear after a short
period of use. It is however advisable
to keep the room well ventilated.
1 2
Out All Day
°
21
C
Out All Day
Heating On
7
NOTE:
Should the heater fail to operate,
this may be caused by the room
temperature being higher than the
thermostat setting.
6 4
3 5