Table of Contents
Advertisement
Product Locks
Product Locks are methods of locking the heater's controller to restrict access to functions. This can be activated
and confi gured via the Advanced Settings Menu.
When Product Lock is activated, the heater continues to run in whichever mode is currently active and any/all
wireless communications remain active if enabled.
Child Lock
This locking method does not utilise a PIN code and is toggled on/off on the heater's controller by pressing and
holding the Back and Enter buttons for three seconds. It is a full Product lock with no exception rules.
PIN Lock
In PIN Lock, all UI buttons other than the Menu button are disabled unless Advance has been enabled during UI
Lock (see section 'Product Lock Settings' on page 15).
In the Main Menu all buttons are active. Two items can be selected:
Boost – Activates Boost Mode. This function can be restricted,
see below.
Unlock - Selecting 'Unlock' prompts the User to complete the
unlock action for the currently active.
PIN Lock Exceptions
It is possible to allow the 'Advance' and 'Boost' functions to be enabled/disabled when PIN Lock is active.
There are up to 4 exceptions. These exceptions include:
- Advance
• Ability to activate using the 'Advance Button'
- Boost
• Ability to activate using the 'hotkey' listed in the Main Menu
• Ability to modify the Boost Temperature
• Ability to modify the Boost Duration
To confi gure these settings, see section 'Product Lock Settings' on page
'Advance Function' Operation during UI Lock
If Advance has been enabled during UI Lock, the Advance button will remain active when UI Lock is active. This
will function in the same way it would if the UI was not locked (only if the Heater is Locked into a Timer Mode).
•
If Advance is enabled during UI lock, the Advance button will function as normal while the Heater is set to a
Timer Mode.
•
If Advance is Disabled during UI lock, the Advance button will not function.
'Boost Function' Operation during UI Lock
If enabled, Boost will function in the same way as it does when PIN Lock is not active unless modifi cation of Boost
Temperature and Boost Duration have been disabled.
Boost Temperature and Boost Duration will be set to the default values when 'Boost' is activated. If either of these
values have been disabled during Product lock, when the user tries to modify them the heater's display will show the
message 'Disabled' and only the default value can be used. The default values can be changed outside of PIN Lock.
Manual
°
21
C
PIN Unlocked
15..
Menu
Boost
Unlock
PIN Lock
134--
Enter 4 Digit
PIN
14
Advertisement
Table of Contents
