First-Time Startup - Dimplex ML Series Quick Start Manual

Electrical Connection
WARNING: THIS APPLIANCE MUST BE EARTHED
DO NOT use an extension lead or multi-plug adaptor when
connecting this product to the mains. Connection through
these devices could lead to risk of overloading, overheating
and even fire at the extension lead or adaptor due to
inadequate connection quality.
This heater must be used on an AC (~) supply only and
the voltage marked on the heater must correspond to the
supply voltage. This heater is fitted with a rewirable plug
incorporating a 10/13 amp fuse. In the event of replacing
the fuse in the plug supplied, an equivalent 10/13 amp fuse
approved by ASTA to BS 1362 must be used. If any other type
of plug is used, a 15 amp fuse must be fitted in the plug, the
adaptor, or at the distribution board.
IMPORTANT: If the plug is not suitable for your socket, the 13
amp plug should be removed. Before wiring the appropriate
plug, please note that the wires in this mains lead are coloured
in accordance with the following code:
GREEN AND YELLOW:
BLUE:
BROWN:
Connect the GREEN AND YELLOW wire to the terminal
marked 'E' or by the earth symbol
or GREEN AND YELLOW. Connect the BROWN wire to the
terminal marked 'L' or coloured RED. Connect the BLUE wire
to the terminal marked 'N' or coloured BLACK.
General
The heater is designed for operation on an AC electricity
supply, and is suitable for use in domestic dwellings and
similar indoor locations.
The heater is supplied with feet and handles for ease of
movement. An electronic control provides the ability to
choose an available heat output and control the room
temperature. It is supplied with a cord and plug and is
ready for use once the feet have been correctly fitted.
Assembly and Positioning
The ML Convector can only be used as a portable heater.
To install the feet, lay the heater on its back and remove
the two foot fixing screws, highlighted in Fig. 2. Assemble
the feet by pressing them firmly into the convector body
as indicated in Fig. 2, the foot should clip into position.
Secure using the foot fixing screw, Return the convector to
the upright position,
The appliance is now ready for use.
Always ensure that the heater is stood on a firm, level
base near to, but not directly underneath a suitable mains
supply socket.
Ensure that curtains and furniture are not positioned close
to the chosen position.
If young children, the aged or infirm are likely to be left
in the vicinity of the heater, we advise that the adequate
precautions should be taken. We recommend that a guard
be fitted to ensure contact with the heater is avoided and
objects cannot be inserted into the product.
EARTH
NEUTRAL
LIVE
, or coloured GREEN
WARNING: PLEASE ENSURE THE MINIMUM CLEARANCE
DIMENSIONS INDICATED IN Fig.1 ARE MAINTAINED
WARNING: The heater must only be operated with the feet
securely fitted and in the upright position.
Never use the heater as a portable appliance without the
feet securely fitted using the screws provided.
Operation
IMPORTANT - OBJECTS OR CLOTHING MUST NOT BE
PLACED ON THIS HEATER.
Before using the heater ensure that all warnings and
instructions have been carefully read.
CONTROLS
Decrease Temperature
(Min 5ºC/43ºF)
Runback Timer
FIRST TIME STARTUP
To activate the heater, after assembly, simply plug it in.
You will hear an audible beep and the standby button will
illuminate. This indicates the appliance is energised and
ready for use.
Fig. 2
Increase Temperature
(Max 30ºC/86ºF)
Heating Mode
or
Standby
Fig. 3