Table of Contents
Advertisement
5.2 Using the sensor fields
To activate the function press and hold the
selected symbol on the display for at least 1
second.
5.3 Setting the time
You must set the time before you operate the
oven.
Only the top oven works without the set
time.
The
flashes when you connect the
appliance to the electrical supply, when there
was a power cut or when the timer is not set.
Press the
or
to set the correct time.
After approximately five seconds, the flashing
stops and the display shows the time of day
you set.
5.4 Changing the time
You cannot change the time of day if any
of the functions operates.
6. HOB - DAILY USE
WARNING!
Refer to Safety chapters.
6.1 Hob control panel
Press
for the Time of Day function flashes.
To set a new time, refer to "Setting the time".
5.5 Preheating
Preheat the empty oven before first use.
Preheat the two ovens before first use.
Heat up one oven at a time.
Set the functions listed below, if
applicable.
1. Set the function
2. Let the oven operate for 1 hour.
3. Set the function
4. Let the oven operate for 15 minutes.
5. Set the function
6. Let the oven operate for 15 minutes.
7. Turn off the oven and let it cool down.
Accessories can become hotter than usual.
The oven can emit an odour and smoke.
Make sure that the airflow in the room is
sufficient.
1
2
3
9
8
again and again until the indicator
. Set the temperature
to 250ºC.
. Set the temperature
to 250ºC.
. Set the temperature
to 250ºC.
4
5
6
7
ENGLISH
11
Advertisement
Table of Contents
