Known Issues - Quantum Scalar 10K Release Note

Known Issues

Change
Request
Number
33359
40518
41203
41301
This release of Scalar 10K firmware has the following known issues. This list contains
cumulative information for the previously released versions.
Service
Request
Number
282830 On occasion, the vertical mounting
of a 3590 tape drive might be higher
than the vertical window expected
by the library firmware to
successfully scan for the drive
fiducial. As a result, the library
cannot teach the drive.
When a Teach Current operation is
performed for a DM, a drive teach
failure can return an incorrect bay
number to the Operator Panel.
When using a data tape instead of a
FUP tape to update a list of drives,
the library correctly posts a "BAD
FIRMWARE MEDIA" operator
intervention message, but continues
to the next drive in the list. The
operation should fail and not
continue.
After cleaning cartridges are ejected
from drives, the View dialog (Main
MenuSetupCleaningView)
continues to indicate a Valid status
for the first cleaning cartridge rather
than clearing the status.
Description
Known Issues
Document 6-00016-32 Rev A
September 2007
Workaround
Manually adjust the vertical
placement of the 3590 tape drive or
the front bezel until the library can
successfully teach the drive.
Physically inspect the drive bay that
the failure indicated or possibly the
bay that is located immediately
before. The bay that is identified by
the failure might not exist.
No applicable workaround is
available.
Make sure that cleaning cartridges
are inserted into the library by using
the Insert Clean Tape command
(Main MenuCommands Insert/
EjectInsert Clean Tape). This
operation physically inserts the
cartridges and also inserts them into
the library database.
NOTE: Do not use Main Menu
SetupCleaningMedia to perform
this operation. This operation inserts
the cartridges into the library
database only.
Release Notes
0
5