Table of Contents
Advertisement
c. Please note that when the Capture Number parameter is set higher than "1
Photo", or with very short Interval settings, some images may appear darker
than others due to the quick response and rapid retriggering of the camera,
allowing less time for the flash to fully recharge before firing again.
d. Make sure "LED Control" in the setup menu is set to "High" to ensure
maximum output. You can also try setting "NV Shutter" in the menu to "Low"
(slower shutter speed=brighter images, with tradeoff of increased blur if
subject moves rapidly).
e. The ARD (anti-reflective device) shield can be removed to maximize flash
output. See page 28 for more details.
2. Daytime photos or videos appear too dark
Make sure that the camera is not aimed at the sun or other light sources during
the day, as this may cause the auto exposure to produce darker results.
3. Night photos or videos appear too bright
If the subject is close to the camera (less than10ft/3m), change the LED
Control parameter in the Setup Menu to "Medium" or "Low".
4. Daytime photos or videos appear too bright
Make sure that the camera is not aimed at the sun or other light sources during
the day.
5. Photos with streaked subject
a. In some cases with low lighting conditions and fast moving subjects, the
8MP or 14MP resolution settings may not perform as well as the 3MP setting.
b. If you have multiple images where fast moving subjects produce streaks on
the photo, try the 3MP setting instead.
c. Set "NV Shutter" to "High" to minimize motion blur.
6. Red, green or blue color cast
a. Under certain lighting conditions, the sensor can become confused resulting
in poor color images.
b. If this is seen on a consistent basis, then the sensor may need servicing.
Please contact Bushnell customer service.
7. Short video clips—not recording to the length set
a. Check to make sure that the SD card is not full.
33
Advertisement
Table of Contents
