ZyXEL Communications HD User Manual page 25

Figure 8 WAC5302D-S LEDs
The following table describes the LEDs.
Table 7 WAC5302D-S LEDs
LED COLOR
PWR/SYS Red
Green
Green
Red
Management Green
UPLINK Amber/
Green
WLAN Green
WLAN Green
Chapter 1 Introduction
STATUS DESCRIPTION
Slow Blinking (On for 1s, The LED blinks orange and green alternatively when the
Off for 1s) WAC is booting up.
On
On The WAC is ready for use.
Slow Blinking (On for 1s, The wireless module of the WAC is disabled or failed.
Off for 1s)
On There is system error and the WAC cannot boot up, or the
WAC suffered a system failure.
Fast Blinking (On for The WAC is doing firmware upgrade.
50ms, Off for 50ms)
Slow Blinking (Blink for 3 The Uplink port is disconnected.
times, Off for 3s)
On The WAC AP is managed by a controller.
Slow Blinking (Blink for 3 The WAC AP is searching (discovery) for a controller.
times, Off for 3s)
Off The WAC AP is in standalone mode.
On Amber - The port is operating as a 10/100-Mbps
connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
Blinking The WAC is sending/receiving data through the port.
Off The port is not connected.
On The 2.4 GHz WLAN is active.
Off The 2.4 GHz WLAN is not active.
On The 5 GHz WLAN is active.
Off The 5 GHz WLAN is not active.
NWA / WAC Series User's Guide
25