The CLI screen displays next.
3
14.6 Telnet
You can use Telnet to access the NWA/WAC's command line interface. Click Configuration > System >
TELNET to configure your NWA/WAC for remote Telnet access. Use this screen to enable or disable Telnet
and set the server port number.
Figure 105 Configuration > System > TELNET
The following table describes the labels in this screen.
Table 70 Configuration > System > TELNET
LABEL
Enable
Server Port
Apply
Reset
14.7 FTP
You can upload and download the NWA/WAC's firmware and configuration files using FTP. To use this
feature, your computer must have an FTP client. See
about firmware and configuration files.
To change your NWA/WAC's FTP settings, click Configuration > System > FTP tab. The screen appears as
shown. Use this screen to specify FTP settings.
Chapter 14 System
DESCRIPTION
Select the check box to allow or disallow the computer with the IP address that matches the IP
address(es) in the Service Control table to access the NWA/WAC CLI using this service.
You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Click Apply to save your changes back to the NWA/WAC.
Click Reset to return the screen to its last-saved settings.
NWA / WAC Series User's Guide
Chapter 16 on page 180
162
for more information