Nexgrill 820-0007GE Owner's Manual page 13

BURNERS – Extreme care should be taken when removing and replacing a burner. It must be correctly centred on the orifice
before any attempt is made to relight the grill. Frequency of cleaning will depend on how often you use the grill.
Failure to properly place the burner over the orifice could cause a fire to occur behind and beneath the valve panel, thereby
damaging the grill and making it unsafe to operate. Before cleaning, make sure the gas supply is CLOSED and control knobs are
in the "OFF" () position and the burners have cooled. Disconnect the hose and regulator from the gas cylinder.
STEP 1
To remove the burners for cleaning:
1. Disengage flame tamer from firebox by lifting one of its tabs.
2. Locate the burner pins at the rear of the firebox.
3. Remove the pins and lift the burners out of the firebox.
STEP 2
To clean the grill burners:
1. Clean the exterior of the burner with a wire brush. Use a
metal scraper for stubborn stains or debris.
2. Clear clogged ports with a straightened paper clip. Never
use a wooden toothpick as it may break off and clog the
port.
3. Check and clean burners / venturi tubes for insects and
insect nests. A clogged tube can lead to a fire beneath, and
behind the main control panel.
CLEANING
12