Cleaning The Glass Cover; Malfunction Table - Siemens HB84K.52B Instruction Manual

Fully open the door, while holding the panels firmly with one
3.
hand. (Fig. C).
Push the door downwards again and tighten the screws
4.
hand-tight using a flat-bladed screwdriver (blade width 8-
11 mm), close the door. (Fig. D).
&
Caution!
You must not use the oven again until the panels have been
properly refitted.

Cleaning the glass cover

The glass cover can be removed from the oven ceiling for
cleaning.
ã=
Risk of burns!
Do not remove the panels immediately after switching the
appliance off. The oven must be cold.
Removal
Place a tea towel in the oven.
1.
Pull the clip on the oven ceiling forwards. (Fig. A)
2.
Press the front of the glass cover down using the thumb of
your other hand. Let go of the clip.
Slide the cover forwards using both hands and rest it on the
3.
grill element. (Fig. B)
$
Slide it slightly backwards again. (Fig. C)
4.

Malfunction table

Malfunctions often have simple explanations. Please refer to the
malfunction table before calling the after-sales service.
If a meal does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
'
%
Tilt down at the side and remove. (Fig. D)
5.
&
ã=
Risk of injury!
Never touch or clean the microwave antenna (A)!
For light soiling:
Wash the glass cover using hot soapy water.
For heavy soiling:
Clean the glass cover in the same way as the enamel surfaces
in the oven.
Refitting
Slide in the cover with the smooth side facing downwards
1.
and rest it on the grill element. (Fig. A)
Use both hands to slide it back into the two catches. (Fig. B).
2.
$
Pull the clip forwards and push the glass cover upwards. Let
3.
go of the clip. (Fig. C)
&
Remove the tea towel from the oven.
ã=
Risk of serious damage to health.!
Never operate the appliance without the microwave glass
cover. Microwave energy may escape.
ã=
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
'
$
%
13