Steps
1. Slide the power-supply unit into the chassis until the securing tab snaps into position.
2. Replace the three (#6-32) screws to secure the power-supply unit to the chassis.
3. Route the power cable through the routing guides on the chassis and connect the power cables to their respective
connectors on the system board.
Next steps
1. Install the
fan
duct.
2. Install the
side
cover.
3. Follow the procedure in
Intrusion switch
Removing the intrusion switch
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
fan
duct.
About this task
The following images indicate the location of the intrusion switch and provides a visual representation of the removal procedure.
58
Disassembly and reassembly
after working inside your
before working inside your
computer.
computer.