Table of Contents
Advertisement
3-4. Other interior features
STEP
3
STEP
4
Repeat the steps above to program another device for any of
the remaining HomeLink
■
Programming a Rolling Code system
If your device is Rolling Code equipped, follow the steps under the
heading "Programming HomeLink
steps listed below.
STEP
1
Locate the training button on the ceiling mounted garage door
opener motor. The exact location and color of the button may
vary by brand of garage door opener motor.
Refer to the operation manual supplied with the garage door opener
motor for the location of the training button.
STEP
2
Press the training button.
Following this step, you have 30 seconds in which to initiate step 3
below.
322
Test the HomeLink
by pressing the newly pro-
grammed button.
If a HomeLink
programmed for a garage door,
check to see if the garage door
opens and closes. If the garage
door does not operate, see if your
remote control transmitter is of
the rolling code type. Press and
hold the programmed HomeLink
button. The remote control trans-
mitter is of the rolling code type if
the HomeLink
flashes rapidly for 2 seconds and
then remains lit. If your transmit-
ter is of the rolling code type, pro-
ceed
to
"Programming a rolling code sys-
tem".
buttons.
" before proceeding with the
operation
button has been
indicator light
the
heading
Advertisement
Table of Contents
