Jeep GRAND CHEROKEE L 2023 Owner's Manual page 147

NOTE:
Keeping your foot on the accelerator pedal can

cause the vehicle to continue to accelerate
beyond the set speed. If this occurs, the
message "DRIVER OVERRIDE" will display in the
instrument cluster display.
If you continue to accelerate beyond the set

speed while ACC is enabled, the system will not
be controlling the distance between your vehicle
and the vehicle ahead. The vehicle speed will
only be determined by the position of the accel-
erator pedal.
To Cancel
The following conditions cancel the ACC or Fixed
Speed Cruise Control systems:
The brake pedal is applied

The CANC (cancel) button is pushed

The gear selector is removed from the DRIVE

position
The Electronic Stability Control/Traction Control

System (ESC/TCS) activates
The vehicle parking brake is applied

The Trailer Sway Control (TSC) activates

The braking temperature exceeds normal range

(overheated)
The following conditions will only cancel the ACC
system:
Driver seat belt is unbuckled at low speeds

Driver door is opened at low speeds

To Turn Off
The system will turn off and erase the set speed in
memory if:
The Adaptive Cruise Control (ACC) on/off button

is pushed
Fixed Speed Cruise Control on/off button is

pushed
The ignition is placed in the OFF position

4WD Low is engaged

The Active Driving Assist (ADA) system (if

equipped) is enabled/engaged and the ADA
button is pressed
NOTE:
If ADA is not enabled/engaged and the ADA button
is pressed, the ACC system will remain on or turn
on, depending on the state of ACC at the time of
the ADA button press.
To Resume
If there is a set speed in memory, push the RES
(resume) button and remove your foot from the
accelerator pedal. The instrument cluster display
will show the last set speed.
STARTING AND OPERATING
Resume can be used at any speed above 20 mph
(32 km/h) when only Fixed Speed Cruise Control is
being used.
Resume can be used at any speed above 0 mph
(0 km/h) when ACC is active.
NOTE:
While in ACC mode, when the vehicle comes to

a complete stop longer than two seconds, the
driver will either have to push the RES (resume)
button or press the accelerator pedal to reen-
gage the ACC system.
ACC cannot be resumed if there is a stationary

vehicle in front of your vehicle in close proximity.
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming a
set speed that is too high or too low for
prevailing traffic and road conditions could
cause the vehicle to accelerate or decelerate too
sharply for safe operation. Failure to follow these
warnings can result in a collision and death or
serious personal injury.
145
4