Table of Contents
Advertisement
■
If the tire is inflated to more than the specified air pressure
Disconnect the hose from the valve.
1
Install the air release cap to the end of
2
the hose and push the protrusion on
the air release cap into the tire valve
to let some air out.
Disconnect the hose from the valve, remove the air release cap from
3
the hose and then reconnect the hose.
Turn the compressor switch on and wait for several seconds, and then
4
turn it off. Check that the air pressure indicator shows the specified air
pressure. (P. 762)
If the air pressure is under the designated pressure, turn the compres-
sor switch on again and repeat the inflation procedure until the speci-
fied air pressure is reached.
■
The valve of a tire that has been repaired
After a tire is repaired with the emergency tire puncture repair kit, the
valve should be replaced.
■
After a tire is repaired with the emergency tire puncture repair kit
●
The tire pressure warning valve and transmitter should be replaced.
●
Even if the tire inflation pressure is at the recommended level, the tire
pressure warning light may come on/flash.
■
Note for checking the emergency tire puncture repair kit
Check the sealant expiry date occasionally.
The expiry date is shown on the bottle. Do not use sealant whose expiry
date has already passed. Otherwise, repairs conducted using the emer-
gency tire puncture repair kit may not be performed properly.
PRIUS_OM_OM47C35U_(U)
8-2. Steps to take in an emergency
715
8
Advertisement
Table of Contents
Troubleshooting
