Led Diagnostics; Assembling The Blower - Stihl BGA 45 Instruction Manual

English
1
2
3
4
► Insert the charger plug into a properly installed
electrical outlet (1) with the same voltage and
electrical frequency stated on the charger's
rating plate (2).
► Push the connector (4) into the blower's charg‐
ing socket (5) until it stops.
The LEDs on the blower (6) glow green during
charging and show the state of charge.
When the LEDs on the blower go out, the
charging process is complete and the charger
will shut itself off.
► Remove the charger from the blower and dis‐
connect the charger plug from the electrical
outlet when charging is complete.
A blower is not fully charged when it ships from
the factory. STIHL recommends that you fully
charge the blower before using it the first time.
Operate the charger only indoors, in dry rooms
and within an ambient temperature range of
32 °F to 104 °F (0 °C to 40 °C).
The blower heats up during operation. The
charging process begins only after the blower
and its integrated battery have cooled down suffi‐
ciently.
Charging time depends on a number of factors,
including the condition of the integrated battery
and the ambient temperature. For a complete list
of approximate charging times, see
www.stihl.com/charging-times.
Operation of the blower is disabled during charg‐
ing and any time the blower is connected to the
charger.

11 LED Diagnostics

11.1 Blower Status
LEDs on the blower show the status of the power
tool and its integrated battery.
If three LEDs glow red continuously: the integra‐
ted battery is either too hot or too cold. Allow the
blower to warm up or cool down gradually at an
ambient temperature of about 50 °F to 68 °F
(10 °C to 20 °C).
12
6
5
If three LEDs flash red when you activate the
trigger switch: the blower has an electrical mal‐
function. Do not operate or charge the blower.
Have it checked by an authorized STIHL servic‐
ing dealer before use or storage.
For troubleshooting information,
11.2 Charge Status
The LEDs also show the blower's state of
charge.
To determine the blower's state of charge:
1
► Press the push button (1) on the blower.
The LEDs on the blower will glow or flash
green for about 5 seconds and indicate the
state of charge (see illustration).
For example:
If four green LEDs glow continuously: full charge.
If one green LED is flashing: less than 20 %
charge.

12 Assembling the Blower

12.1 Mounting the Blower Tube and
Nozzle
WARNING
■ Make sure the activation key is removed
before starting assembly. Never operate your
blower without a properly mounted blower
tube and nozzle,
ments supplied or expressly approved by
STIHL, 5.5.
To mount the blower tube and nozzle:
11 LED Diagnostics
22.
80-100%
60-80%
40-60%
20-40%
0-20%
5.7.4. Use only attach‐
0458-719-8221-B