Stihl BR 700 Instruction Manual
  1. Manuals
  2. Brands
  3. Stihl Manuals
  4. Blower
  5. BR 700
  6. Instruction manual

Stihl BR 700 Instruction Manual

Hide thumbs Also See for BR 700:
Table of Contents

Advertisement

Quick Links

{
STIHL BR 700
Instruction Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BR 700 and is the answer not in the manual?

Questions and answers

Related Manuals for Stihl BR 700

Summary of Contents for Stihl BR 700

  • Page 1 STIHL BR 700 Instruction Manual...

  • Page 3: Table Of Contents

    English Contents Dear Customer, Guide to Using this Manual Safety Precautions and Working Thank you for choosing a quality engineered STIHL product. Techniques Assembling the Unit It has been built using modern Adjusting the Throttle Cable production techniques and comprehensive quality assurance.

  • Page 4: Guide To Using This Manual

    English Engineering improvements Guide to Using this Manual Safety Precautions and Working Techniques STIHL's philosophy is to continually improve all of its products. For this Special safety precau- Pictograms reason we may modify the design, tions must be observed engineering and appearance of our...
  • Page 5 STIHL or are technically identical. If you machine. Tie up and con- Intended Use have any questions in this respect, fine long hair (e.g.
  • Page 6 – refer blower housing is damaged, consult Gasoline is an extremely to appropriate chapters in the instruction your dealer – STIHL recommends you flammable fuel. Keep manual. contact a STIHL servicing dealer. clear of naked flames. Do Check the fuel system for leaks, not spill any fuel –...
  • Page 7 – risk of your ability to hear warnings (shouts, stumbling. If dust levels are very high, always wear alarms, etc.) is restricted. a suitable respirator. BR 700...
  • Page 8 – not early in advice. Use only a spark plug of the type the morning, late at night or during approved by STIHL and make sure it is midday rest periods when people Maintenance and Repairs in good condition – see "Specifications".

  • Page 9: Assembling The Unit

    Push the hose clamp (1) onto the pleated hose (2). Line up the positioning marks on the hose clamp (1) and elbow (3) – the screw eye faces down. Secure the hose clamp (1) with the screw (4). BR 700...
  • Page 10 (3) are covered. Pull the nozzle (1) off the blower Loosen the union nut (1). tube (2). Pull the blower tube (1) out to the required length. Tighten the union nut (1). BR 700...

  • Page 11: Adjusting The Throttle Cable

    Then rotate it another half turn in the same direction. Pull the ends of the straps downward. Secure the blower tube to the handle on the backplate with the hook and loop fastener. BR 700...

  • Page 12: Fuel

    Use only high-quality two-stroke engine STIHL MotoMix uses STIHL HP Ultra oil – preferably STIHL HP, HP Super or two-stroke engine oil for an extra long HP Ultra, which are specially formulated engine life.

  • Page 13: Fueling

    Opening screw-type tank cap light, the sun, low or high temperatures can quickly make the fuel mix unusable. STIHL MotoMix may be stored for up to 2 years without any problems. Thoroughly shake the mixture in the canister before fueling your machine.

  • Page 14: Winter Operation

    English Filling up with fuel Winter Operation Take care not to spill fuel while fueling and do not overfill the tank. STIHL recommends you use the STIHL filler nozzle (special accessory). Closing screw-type tank cap At temperatures below 10°C: Swing the shutter (4) to the winter position (r).

  • Page 15: Information Before You Start

    Press the manual fuel pump bulb at setting lever (1) is not locked in this least five times – even if the bulb is position. It springs back to position “F”. filled with fuel. The ignition is switched on again. BR 700...
  • Page 16 At very low outside temperatures Crank the engine until it begins to fire. After no more than three Open throttle slightly – warm up the attempts, turn the choke knob to n. engine for a short period. BR 700...

  • Page 17: Operating Instructions

    Set the choke knob according to engine temperature. Now start the engine. Push the setting lever (1) upwards. The throttle trigger (2) is in the full throttle position. Continue cranking until the engine runs. BR 700...

  • Page 18: Replacing The Air Filter

    Replace dirty or damaged filters. Fit the new filter in the filter housing. Fit the filter cover. Insert the screws and tighten them down firmly. Turn the choke knob to l. Loosen the screws (1). Remove the filter cover (2). BR 700...

  • Page 19: Spark Plug

    Fit a new spark plug after about 100 operating hours – or sooner if the electrodes are badly eroded. Install only suppressed spark plugs of the type approved by STIHL – see "Specifications". Clean dirty spark plug. Check electrode gap (A) and Removing the Spark Plug readjust if necessary –...

  • Page 20: Storing The Machine

    Have the pickup body in the fuel Dispose of fuel properly in tank replaced every year. accordance with local STIHL recommends that you have environmental requirements. servicing and repair work carried out Run the engine until the carburetor exclusively by an authorized STIHL is dry –...

  • Page 21: Maintenance And Care

    Have decoked by servicing dealer Combustion chamber after first 139 hours of operation, then every 150 hours of operation All accessible screws and nuts (not adjust- Retighten ing screws) Check Anti-vibration elements Have replaced by servicing dealer BR 700...
  • Page 22 (very dusty work area, etc.), shorten the specified intervals accordingly. Check Blower air intake screen Clean Check Base plate Clean Throttle cable Adjust Safety labels Replace STIHL recommends an authorized STIHL servicing dealer. BR 700...

  • Page 23: Minimize Wear And Avoid Damage

    English servicing dealer. STIHL dealers are Minimize Wear and Avoid regularly given the opportunity to attend Damage training courses and are supplied with the necessary technical information. Observing the instructions in this manual helps reduce the risk of unnecessary If these maintenance operations are not wear and damage to the power tool.

  • Page 24: Main Parts

    13 Air filter 14 Tank cap 15 Base plate 16 Spark plug boot 17 Carburetor adjusting screws 18 Choke knob 19 Manual fuel pump 20 Starter grip 21 Fuel tank 22 Muffler Serial Number Not in all versions, country-specific BR 700...

  • Page 25: Specifications

    K-factor in accordance Engine with Directive 2006/42/EC is 2.0 m/s Noise and Vibration Data for the vibration measurement. STIHL 4-MIX Engine REACH Noise and vibration data are measured Displacement: 64.8 cc at idling and maximum rated speed in a...

  • Page 26: Maintenance And Repairs

    Take the product, replacement parts which have been accessories and packaging to an conforms to the relevant requirements of approved by STIHL for this power tool or approved disposal site for environment- the Directives 2006/42/EC, are technically identical. Only use high- friendly recycling.
  • Page 27 English ANDREAS STIHL AG & Co. KG Produktzulassung (Product Licensing) The year of manufacture and serial number are applied to the product. Done at Waiblingen, 10.03.2016 ANDREAS STIHL AG & Co. KG Thomas Elsner Director Product Management and Services BR 700...
  • Page 28 0458-459-0121-B englisch www.stihl.com *04584590121B* 0458-459-0121-B...

Table of Contents

Save PDF