Omron Delta 5 User Manual page 41

No.
1 M5 bolt with washer
2 Slider clamp bottom
3 Plain bearing
• Unscrew the two M5 bolts with washer and take of the slider clamp bottom
• Now exchange the old bearing with a new one
• Put back the slider clamp bottom and the two M5 bolts with washer
• Repeat this for the other side of the axis
1
2
3
No.
1 2 x M5 bolt with washer
2 Slider clamp top
3 1 x M5 bolt with washer
4 Top connector
• Unscrew the three M5 bolts with washer from the top connector and the slider clamp top
• Remove the top connector from the tubes
• Remove the slider clamp top with the plain bearings
• Now exchange the old plain bearings with the new ones
• Put back the slider clamp top and the M5 bolt with washer
• Mount the top connector with the two M5 bolts with washer on the two tubes
WARNING
• PLAIN BEARINGS HAS TO BE MOUNTED VERY CAREFULLY.
• WRONG MOUNTED PLAIN BEARINGS MAY DAMAGE.
• EXTEND THE ROTATIONAL AXIS TO ITS ENTIRE LENGTH, THEN RETRACT THE SAME AND CHECK WHETHER IT IS
EASY TO OPERATE OR WHETHER SOME RESISTANCE OCCURS.
Description
4
Description
4
4-3