Landscape Forms Carousel Instructions

Instructions
10/2014
Carousel Table with Four Seats

Table Components:

(2) table/seat supports
(1) table top
(4) seats
Note: Marneaux tabletop ships with a circular adapter plate installed, do not remove.

Hardware:

(18) 1/4" x 3/4" Phillips tapping screws for Steelhead and Catena table top OR
(4) 1/4-20 x 3/4" Phillips machine screws with washers for Marneaux table tops
(6) 3/8-16 x 1" hex head machine screws with washers for seats
(1) 1/4-20 x 2-1/4 Phillips machine screw and lock nut for umbrella (sold separately)
(Glides for freestanding support and anchor tabs for surface mount support are factory installed.)

Tools Required:

#3 Phillips screwdriver for Steelhead, Catena, and Marneaux table tops
9/16" socket and ratchet for seat screws
HANDLE WITH CARE! Pangard II polyester powder coat is a strong, long-lasting finish. Protect this finish from damage during
assembly. Place unwrapped powder coated parts on packaging foam or other non-abrasive surface. Do not place or slide
powder coated parts on concrete or other hard or abrasive surfaces – this will damage the finish causing corrosion to occur. Use
touch-up paint to repair any finish abrasions.

Assembly:

1. Lay table top upside down on a non-marring surface.
2. Place support A (has 5" ring at center) upside down on table top. Insert screws loosely (6 for Steelhead and Catena or 2 at
ends of plates for Marneaux).
3. Hold support B upside down and carefully lower it over support A. Place bar of support B into notch in ring on support A.
Insert screws loosely as before.
Carousel Table with Four Seats continued
4. Tighten all table top fasteners until snug, then tighten additional 1/4 turn.
recommended with Marneaux tabletops. Threaded inserts may be damaged or broken due to over-torquing.]
5. Turn table right side up, using at least 2 people.
SUPPORT "A"
SUPPORT "B"
[The use of power drivers is not
Assembly Installation Operation
Page 1 of 2