Landscape Forms Carousel Installation Manual

Carousel
dining height table
Installation Guide
dining ht SUPPORT 'A'
dining ht SUPPORT 'A'
1X – 3 seat
dining ht SUPPORT 'B'
1X – 3 seat
1X – 4 seat
1X – 6 seat
42" dia tabletop
42" dia tabletop,
Steelhead solid
Marneaux or Catena
Adapter
Plate - 3 seat
39" square wood
unit only
Tabletop
Backless
Backless
Grid seat
perf seat
NOTCH
AT 90°
dining ht SUPPORT 'A'
1X – 5 seat
1X – 4 seat
1X – 6 seat
dining ht SUPPORT 'B'
dining ht SUPPORT 'C'
1X – 5 seat
42" dia tabletop
42" dia wood
Tabletop
Backed Backed
grid seat perf seat
ASSEMBLE WITH CARE! Pangard II Polyester Powdercoat is a strong, long-lasting finish. To
protect this finish during assembly, place unwrapped powdercoated parts on packaging foam or
NOTCHES
AT 60° other non-marring surface. Do not place or slide powdercoated parts on concrete or other hard
or textured surface – this will damage the finish causing rust to occur. Use touch-up paint on any
gouges in the finish caused by assembly tools.
WARNING! ALL 3-SEAT TABLES AND ALL TABLES USED WITH METAL
UMBRELLAS MUST BE FASTENED SECURELY TO HARD SURFACING TO
PREVENT TIPPING.
Included components:
• Support 'A' and 'B' for 3 or 4 seat units
• Support 'A', 'B' and 'C' for 5 or 6 seat units
• Seats (qty and style depends on order)
• 1 tabletop per unit, with attaching hardware
• (1) ¼-20 x 2-1/4" Phillips pan head machine
screw and lock nut
1X – 5 seat
1X – 6 seat
Tools required:
• protective padding
• Phillips head screwdriver
• Non-corrosive anchors, maximum Ø3/8" [9mm] – 3 for 3-seat unit, 4 for 4-seat unit,
6 for 5 or 6 seat units
Steelhead perf
• 9/16" wrench (for seats)
• 5/32" hex key
• 7/16" wrench (for umbrella hardware)
PROCEDURE FOR ASSEMBLING SEATS: See Fig 11. This should be done after
assembling supports to tabletop.
Note: These instructions apply to all seat styles for Carousel units. Seats were NOT
designed to swivel. Allowing the seat to swivel will damage the finish and the
product.
1. Slide seat stem into tube on support. Backless seats should be installed with
the flat part of the stem facing in toward the center of the table.
2. Align threaded hole in seat stem with hole in support tube. This may require
lifting the seat slightly.
3. Insert washer and hex head machine screw through the support hole and
Hoop
tighten. Screws are coated with a dry thread locking compound that cures in 24
seat
hours. Wiggle seats and tighten as necessary until seat is securely fastened.
Date: January 31, 2020
www.landscapeforms.com Ph: 800.521.2546
1X per seat –
1X per seat - 3/8-
3/8 washer
16 x 1-1/2"
indented hex
head machine
screw
Page 1 of 4