Console Operation; General Operation - Diamondback 510T Operating Instructions Manual

Exercise Information

Console Operation

I
MPORTANT
l The console will turn off automatically
approximately ten minutes after the belt
stopped, press any button on the console to
wake it up.
SAFETY KEY
l The safety key must be placed into the
magnetic recess on the console in order to
operate the treadmill. Always place the safety
key in this position and attach the clip to your
clothing waist band before beginning your
workout.
If you should need to stop the motor
l
immediately, simply pull the safety key away
from the console.

GENERAL OPERATION

1. Turn on the power switch at the front of your
treadmill. This switch is located next to the
main power cord inlet.
2. Place the safety key into the magnetic recess
on the middle front of the computer console.
The console will beep and all console window
displays will function with a start display value of
0.
Note: If the Safety Key is not placed correctly or is
faulty, the "Speed" window will display "E00",
which indicates that the treadmill will not operate.
If the Safety Key is removed during exercise, the
console will beep and "Speed" window will display
"E00" and the treadmill will stop.
To stop the treadmill in an emergency, simply pull
the safety key or press the red STOP button in the
centre of the console. It is important that you
connect the clothing clip to your shirt or other
suitable clothing during exercise to ensure that
this safety system can operate easily.
Note: The readings displayed by the computer
should not be used for therapeutic purposes as
they can vary due to the sensitivity of the
equipment. Over exercising may result in serious
injury or death. If you feel faint stop exercising
immediately.