Troubleshooting - Diamondback 510T Operating Instructions Manual

Care and Maintenance
Trouble Shooting
Symptom Cause and Check
E00 Safety Key not in the position
No signal to Controller from
E01
console
E02 Motor communication error
E04 Incline Motor communication
error
E05 Over current protector
E06 Motor Open Circuit
E08 IC Driver Error
E09 Folding up protect
E10 Motor instantaneous current
abnormal
E11 Over voltage protector
E13 No singnal to console from
Controller
E14 Lower voltage protector
Re-locate the safety key in the correct position
A: Check the Main Controller Wire
B: Replace the PCB Board
A: Check the wire from motor to controller
B: IGBT breakdown, Replace the controller
C: Check the power voltage if 50% lower than rate
voltage
D: Replace the motor wire or change motor
A: Check the wire from incline motor to controller
B: Replace the incline motor
C: Replace the controller
A: Over loading or over resistance, restart the treadmill
B: Transmission parts seized up, check the parts
C: Replace controller
D: Motor breakdown, change the motor
Connect the Motor link
Replace the IC driver or change the IC driver
A: Do not fold up the running deck when treadmill in is
running
B: If the running deck in laying position and show E09,
you need change the contoller
A: Adjust the torsion potentiometer of the Controller to
lower
B: Motor Breakdown, change the motor
Voltage over 270v (for 220v) or 150v (for 110v) -- turn off
the treadmill and check the power source
A: Check the Main Controller Wire
B: Change the controller
Voltage lower than 160v (220v) or 70v (110v) -- turn off
the treadmill and check the power source
Solution