Volvo XC40 Owner's Manual page 503

5. Using the lug wrench, screw the towing
eye into place as far as possible according
to the instructions.
CAUTION
The towing eyelet must be screwed into
the lug wrench* as far as possible.
6. Remove the plastic covers from the wheel
bolts using the designated tool.
7. With the vehicle still on the ground, use
the lug wrench/towing eye to loosen the
wheel bolts ½-1 turn by pressing down-
ward (counterclockwise).
8. When hoisting the vehicle, it is important
that the jack or garage lift arms are posi-
tioned on the designated points under the
vehicle. The triangle markings on the plas-
tic cover indicate where the jack attach-
ment points/lifting points are located.
There are two jack attachment points on
each side of the vehicle. There is a groove
for the jack at each attachment point.
9. Position the jack under the attachment
point being used, ensuring that the sur-
face is firm, flat and not slippery.
WHEELS AND TIRES
10. Crank it up until it is properly aligned and
it is in contact with the vehicle's jack
attachment point. Make sure the top of
the jack (or the garage lift arms) is cor-
rectly positioned in the attachment point,
with the bump on the top of the jack in the
recess in the attachment point and the
base positioned vertically under the
attachment point.
11. Turn the jack so that the crank is as far as
possible from the side of the vehicle,
which will position the jack's arms per-
pendicular to the vehicle's direction of
movement.
12. Raise the vehicle until the wheel to be
changed can move freely. Unscrew the
wheel bolts and lift off the wheel.
Related information
When changing wheels (p. 498)
•
Hoisting the vehicle (p. 539)
•
Jack* (p. 499)
•
Attaching and removing the towing eyelet
•
(p. 405)
Installing a wheel (p. 502)
•
* Option/accessory.
501