Location Of Torch For Tandem Arc Applications - Miller RAD-400EF Owner's Manual

5-7. Location Of Torch For Tandem Arc Applications

6
5
4
Torch Right Of Center
(With tilt angle adjusting knob on left side)
1 Feed Plate
The feed plate can be set up with the torch
in two different locations for tandem arc ap-
plications.
To change the tilt angle adjusting knob
to the left side:
2 Hub Clamp Screw
Loosen hub clamp screw.
3 Manipulator Block Screws
Remove manipulator block screws and
block assembly.
OM-256907 Page 18
.
Follow instructions below to change torch to right of center or left of center.
1
3
.
4 Insert Screws
Remove insert screws.
5 Insert Block
Remove insert block
6 Hub Clamp Assembly
Turn hub clamp assembly 180 degrees.
Reassemble in reverse order of disassem-
bly.
.
Re-tighten hardware when the assem-
bly is in the desired position.
Assembly As Shipped
(With torch right of center)
8
Motor shown without
Torch Left Of Center
feed roller guard.
To change the torch to left of center:
7
Loosen feed plate screw.
Turn feed plate 180 degrees.
Re-tighten feed plate screw.
8
Remove inlet guide and install in correct
position.
.
Tools Needed:
1/4, 3/16 in.
2
7
254 579-C / 254 695-C
Feed Plate Screw
Inlet Guide
See applicable controller Owner's
Manual when changing motor direction
for correct wiring instructions.