Navigating Within The Installer Menu; Modifying Installer Menu Settings; Exiting The Installer Menu And Activating Settings - LG ProCentric 55UV560H Commercial Mode Setup Manual

As part of the Installer Menu header (in all modes), two 3-character acronyms are displayed to indicate
the TV's current configuration mode. The table below lists all possible mode identifiers for these TV
models.
Acronym Description
CPU-CTV Pass-through Mode with Channel Lineup in CPU
CPU-FTG FTG Mode via CPU
CPU-P:C Application Tuning Mode via CPU
MPI-EXT External MPI Control
PTC-CTV Pass-through Mode with Channel Map in PTC

Navigating Within the Installer Menu

Use the Up/Down arrow keys on the Installer Remote to sequence through the available menu items,
or access an item directly by keying in the item number and then pressing MENU SETTINGS. For
example, to access the SLEEP TIMER option, which is item 015, press 0-1-5 + MENU SETTINGS.
Installer Menu items not relevant to these TV models are not present in the Installer Menu; therefore,
some numbers are missing. For example, item 006 will not appear. In addition, items that are
dependent on other Installer Menu item settings will not be initially accessible. For example, item 046
STRT AUX SRCE will not display in the Installer Menu unless item 004 STRT CHANNEL is set to 0.
See Installer Menu detailed descriptions for further information.

Modifying Installer Menu Settings

Refer to the table starting on the next page for an overview of the available Installer Menu items,
including their item numbers, functions, value ranges, and default values.
To change an Installer Menu item value, use the Left/Right arrow keys on the Installer Remote to
select the appropriate value, or direct enter a valid value. To save the new setting, press OK once
on the Installer Remote. If you have additional items to modify, use the Up/Down arrow keys to
navigate to a new Installer Menu item or access an item directly as described in the previous section.
Note that invalid values will not be saved.
Caution: In order for Installer Menu item changes to be saved, you must press OK as
indicated above and then exit the Installer Menu as described below. Never remove
power from the TV while in the Installer Menu. Also, remember that Installer Menu
settings may affect options available from the TV setup menus or the Function Menu.

Exiting the Installer Menu and Activating Settings

After you have saved all desired Installer Menu item changes (i.e., press OK once on the Installer
Remote to save changes), press OK again to exit the Installer Menu. Any changes you make will be
stored in non-volatile memory.
Note: Each time you exit the Installer Menu in Pass-through Mode, all V-Chip (Parental Control)
settings in the TV are reset to their default values; that is, the Lock System, if previously enabled from
the Safety Menu, will now be disabled, and the individual Parental Control settings will be restored to
default values.
206-4326
Installer Menu (Cont.)
31